Fitting ARB Rear Bumper Part7

After a short break I started on my project again. Now was time to fit al the little bits and bobs on to the bumper. The instruction from ARB is very clear and the best is to do it step by step as instructed.


Centre locator assembly has to be fitted first.

Before fitting the surrounds, braces need to be fitted.

Catches and red bump stop fitted on to the wheel carriers.

Swing arm struts are fitted next.

Catch

Also a slide locking pin and bracket need to be fitted to look both carriers in the open position. I found out it is not necessary to used it when on a flat surface but I could imaging on a slope is it important.

The final product

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s